Advanced X-ray inspection system featuring open X-ray tube technology, high-definition flat panel detector, and precision 5-axis motion control for comprehensive component analysis.

Key Advantages

Open X-ray tube: no service life limit, only filament replacement needed
New-generation 5" HD FPD with 60° tilt and 360° rotation capability
400×400mm worktable with 10KG load capacity, auto navigation window, and speed-adjustable 5-axis linkage
Optional ACT/PCT 3D CT functions for extended detection capabilities
User-friendly operation: 2-hour training requirement, fast defect locating

Hardware Parameters

X-ray Source
Type	Open, microfocus
Max tube voltage	160kV
Max tube current	500μA
Target power	15W
Tube power	65W
Focal spot size	1μm
Flat Panel Detector
Effective area	130mm×130mm
Pixel size	49.5μm
Resolution	1536×1536
Frame rate	20fps
Tiltable angle	60°
Rotation angle	360°
Table
Size	400mm×400mm
Detectable area	400mm×400mm
Max load	10kg
Equipment
Geometry Magnification	2500X
Inspection speed	Max 3.0s/point
Dimensions	1550mm (L) × 1600mm (W) × 1700mm (H)
Weight	1800kg
Power supply	AC110-220V 50/60HZ
Max power	1800W
Industrial PC	I7 CPU, 16G RAM, 240GB SSD+1TB HDD
Display	24" HDMI LCD
Safety Features
Radiation leakage	No leakage, international standard: ≤1μSv/h
Lead glass observation window	Transparent lead glass window shields radiation to observe the inner status
Window and back door safety interlock	X-ray tube powers off immediately when window or back door is opened
Electromagnetic safety switch	Locks when X-ray is on, preventing observation window opening
Emergency stop	Located next to operation position, press to power off
Tube protection	Software prevents user from leaving without closing X-ray tube

Working Principle

X-ray Inspection Working Principle

Software Functions

Function Module
Operation	Keyboard and mouse can finish all operations
X-ray tube control	Mouse-click X button to turn on/off X-ray. Real-time voltage and current display with adjustable controls
Status bar	Indicates interlock status, pre-heat status, and X-ray status by flashing alternately red and green
Image effect adjustment	Brightness, contrast and gain adjustable for optimal image quality
Product list	Save inspection parameters for efficient recall when inspecting same products
Navigation window	Click anywhere in table photo to move table to selected position
Motion axis status	Display real-time coordinates
Inspection result	Measurement results (voids rate, distance, area, etc.) display in order
Speed control	Movement speed of each axis adjustable to slow, normal and fast
Voids Rate Measurement
Automatic calculation	Click two points to define rectangle for automatic solder ball edge detection and voids measurement
Parameters adjustment	Adjust grayscale threshold, pixel, contrast, size filtering for accurate results
Add voids manually	Draw polygon or free figure to calculate as void into void rate
Save parameters	Save measurement parameters for efficient recall on same products
Other Measurement Functions
Distance	Measure vertical distance from point to baseline
Distance rate	Calculate percentage ratio for through-hole soldering rate measurement
Angle	Measure angle between rays
Radius	Measure round components circumference, area and radius
Perimeter	Measure square components length, width and area
Automatic Inspection
Manual setting	Set any positions as inspection points for automatic inspection and image saving
Array	Automatic inspection of regular points using row and column configuration
Automatic identification	Software automatically identifies positions with obvious features for measurement