Magnification	Geometry 150X \| System 1500X
Inspection Speed	Max 3.0s/point
Dimensions	1100mm (L) × 1000mm (W) × 1600mm (H)
Weight	1000kg
Power Supply	AC110-220V 50/60HZ
Max Power	1300W
Industrial PC	Intel I5 CPU, 8G RAM, 240GB SSD
Displayer	24" HDMI LCD

Safety Features

Radiation Leakage	No leakage
Lead Glass Observation Window	Transparent lead glass window shields radiation to observe internal status
Window and Back Door Safety Interlock	X-ray tube powers off immediately when window or door opens
Electromagnetic Safety Switch	Locks when X-ray is on, preventing window opening
Emergency Stop	Located next to operation position for immediate power cutoff
Tube Protection	Software prevents leaving without closing X-ray tube

Software Function

Function module	Operation	Using Keyboard and mouse
X-ray tube control	Using mouse to click the X button
Status bar	Indicates the interlock status, pre-heat status, and X-ray status by flashing alternately red and green
Image effect adjustment	The brightness, contrast and gain of the image can be adjusted freely
Product list	Users can save the inspection parameters such as Z-axis position, brightness, contrast and gain...
Navigation window	The table will move to the place you click and display on the screen.
Motion axis status	Display real-time coordinates.
Inspection result	The measurement results (voids rate, distance, area, etc., set by users) display in order.
Speed control	The movement speed of each axis can be adjusted (slow, normal and fast)
Voids rate measurement	Automatic calculation	Click on two points to determine a rectangle.
Parameters adjustment	Users can adjust the grayscale threshold, pixel, contrast, size filtering and other parameters.
Add voids manually	Users can draw a polygon or a free figure and calculate it as a void into the void rate.
Save parameters	Users can save parameters and can directly save the parameters.
Other measurement function	Distance	Click the A and B points to set as the baseline, then click the C point to measure the vertical distance from the C point to the baseline.
Distance rate	It is mostly used to measure the soldering rate of the through-hole.
Angle	Click the A and B points to set as the baseline, then click the C point to measure the angle between the BA and BC rays.
Radius	Click three points to determine a circle and measure the circumference, area and radius.
Perimeter	Click two points to determine a square, measure the length, width and area.
Automatic inspection	Manual setting	Users can set any positions on the table as inspection points, the software will automatically inspect and save the picture.
Array	Set two of the inspection points and the number of rows and columns, the software will automatically inspect each point and save pictures.
Automatic identification	The software automatically identifies the positions, takes measurements, and saves the image.